Philips Universal Remote Control Programming Instructions

Program your audio and video devices with Philips Universal remote codes, simple steps for programming Philips universal remote are listed. you can control your TV, Audio devices and SAT box with one Philips Universal Remote codes.

If your remote has code search feature, her is out quick step-by-step guide on How to Program Philips Universal remote with Code Search Button.

Philips Universal Remote Programming Instructions

1. Turn on the device (TV, DVR, etc.) you wish to operate.
2. Press and hold the SETUP button until the red light indicator remains lit, then release the SETUP button.
3. Press and release the desired mode button (TV, DVR, etc.). The red light indicator flashes, then remains lit.
4. Enter one of the 4 digit code from the code table below
5. With the device turned on, press several buttons to test if the Device responds. If the device responds properly, you have successfully found a valid code for your device.
6. Repeat steps 1 to 4 for other devices you wish to set up the Remote control for.

Notes

1. After a valid code entry, the red light indicator turns off.
2. For an invalid code, the red light indicator flashes first, and then turns off. In this case you have to enter Setup mode again and enter a new code.
3. If some buttons do not operate your equipment, try one of the other codes for your brand.

 Remotes for TV

guide