Universal Remote Control Programming Instructions for Sylvania TV

Using the code(s) provided above, program the remote control directly using the following steps.

1. Enter Setup Mode

   Press and hold down the SETUP button on the remote until the red light on the remote turns on. Release the SETUP button. The red light will remain on.

   NOTE: The red light with either be a small light at the top of the remote or the power on/off button.

2. Press the device type button

   Press and release the device button on the remote for the type of device you wish to control. The red light will blink once and remain on.

   NOTE: If there is not a device button on the remote for your type of device, you can use any device button on the remote.

3. Enter the device code

   Use the number buttons on the remote to enter the first code shown above. The red light will turn off after entering the fourth digit.

4. Tests the results

   Point the remote at the device. Test the buttons on the remote to see if the device responds as you would expect. If the buttons do not operate the device, return to Step 1 above and use the next code in the list.

5. Repeat this process for your other devices