following instructions in sequence. In case of a mistake, the process can be exited at any point by pressing and holding the Text/SHIFT  button and then at the same time pressing the STOP button. The remote control will revert to normal operation and no TV brand code will be stored.

1. Determine the manufacturer of your TV set.

2. Look up the 4-digit manufacturer code supplied on the reverse side of this sheet and make a note of this code.

3. Make sure your TV set is turned on. (The set-top box does not  need to be turned on to perform this programming feature).

4. Press and hold both the 1 and the 3 buttons at the same time on the remote control for approximately 3 seconds until the TV standby button remains lit, then release both buttons.

5. Now enter the 4 digit manufacturer code for your TV set. On each digit entry the TV standby button will flash. On entry of the 4th digit the TV standby button will flash then remain lit.

6. Point the remote control at the TV set and press and hold down the TV Standby button or the Mute button on the remote control.

7. When the TV either turns off or brings up the MUTE symbol on screen, release the button. This may take a few minutes to

happen.

8. Press and hold the Text/SHIFT button and then at the same time  press the STOP button to finish setting up the TV control mode. The TV standby button will go out. The TV control function is now programmed into the remote control. 

The following buttons should now operate the TV set: TV Standby,

AV source select, Volume Up, Volume Down, Mute.

If all the above mentioned buttons do not operate the TV set, a KEY FIX operation can be performed. (See Key Fix section). Should the TV model be changed and the remote control requires  re-programming, repeat the above setup procedure with the new TV. If the TV brand is not successfully found by the remote control, the TV standby button will flash rapidly and the remote control will revert to normal operation. No TV brand code will be stored.

TV control setup: Auto Search

If the TV brand is not successfully found by the previous Brand Search, the Auto Search method can be used. 

Notice: this process may take a long time to find your TV code (in cases up to 5 minutes).  Make sure your TV set is turned on. (The set-top box does not need to be turned on to perform this programming feature).

1. Press and hold both the 1 and the 3 buttons at the same time on the remote control for approximately 3 seconds until the TV standby button remains lit, then release both buttons.

2. Point the remote control at the TV set and press and hold down the TV Standby button or the Mute button on the remote control.

3. When the TV either turns off or brings up the MUTE symbol on screen, release the button. This may take up to 5 minutes to happen.