Use the following directions to program your VIZIO Universal Remote Control to use with your ZENITH NETWORK Cable device.

1. Manually turn on your TV (or device you want to control)

2. Press the TV (or device) button and hold for 5 seconds until the LED flashes twice. LED will remain lit.

3. Enter one of the programming code from the list 0527 for your ZENITH NETWORK Cable device. enter it using the Number Buttons. The LED flashes once after entering each digit. If the code is accepted, the LED flashes twice after the last digit is and then turns off. 

4. Point the VIZIO remote control at the device and press the POWER button. If the device powers off, setup is complete. If not, repeat steps with a different code.

Brand: ZENITH NETWORK.

Device Type: Cable .

Remote Code List:0527